Window Film Installation Instructions

Make up a slip solution using washing up liquid mixed with cold water. In the 5 litre pressure sprayer pictured you will need 3-5 small squirts of washing up liquid, width he smaller 500ml manual sprayer shown 1 small squirt will be sufficient.

Measure and note the width and height of the glass from frame to frame or, if there is a rubber inner edge, measure from rubber to rubber.

Cut the film to a little over sized. We recommend leaving the film an inch wider and longer than the glass so that it ca be trimmed when its on the window to the exact contour of the frame. This is because most frames are not perfectly straight and gaps can occur if you try to pre cut it before you install the film.

Spray a fine spray of the slip solution all over the glass (this is so that the glass scraper will glide freely over the window when cleaning).